02-16-2010 12:55 PM - edited 03-15-2019 09:26 PM
Does anyone have a doc on comptability matrix for the 2900 routers? We are starting to order these for our remote sites, but we are sitting at 6.1.3.
Thanks
Solved! Go to Solution.
02-16-2010 01:02 PM
Looks a minimum of 6.1.5 is required for the 2900 series.
http://www.cisco.com/en/US/prod/collateral/routers/ps259/product_data_sheet0900aecd8057f2e0.pdf
Hope this helps.
Brandon
02-16-2010 01:01 PM
If you are looking to run MGCP on the 2900 ISR, I think you may be out of luck. My 6.1.4 doesn' t recoginize a 2900 series type for MGCP. It will probably be available in a patch sooner or later, but I don't know when.
However, if you want to run H.323, you should be fine. CUCM doesn't care what hardware is running the gateway if it's using the H.323 protocol.
Chris
02-16-2010 01:02 PM
Looks a minimum of 6.1.5 is required for the 2900 series.
http://www.cisco.com/en/US/prod/collateral/routers/ps259/product_data_sheet0900aecd8057f2e0.pdf
Hope this helps.
Brandon
02-16-2010 01:08 PM
Thanks, yeah, looks like 6.1.5 is going to be my route. It was just released a week ago or so, so I will be
holding off for a bit.
Thanks again
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: