02-17-2010 01:06 PM - edited 03-04-2019 07:32 AM
Hi,
I have a ATM link (45Mb/s) between 2 location . In one of my locations I multicast 4 diffrent Video traffic. But my 4 multicast traffic is going to the source router by 1 Fastethernet port and after that it's going to destionation over the ATM link. now I have an issue on destionation router . I need to seperate 4 multicasts traffic on the destionation router . it has to be 1 on of my multicast traffic going through VLAN 123 and the others 3 multicast traffics going through VLAN 200.
now all of the multicast traffic is going trough vlan 123.
any body can help me on this issue?
thanks
Mike
02-17-2010 01:22 PM
Hello Mike,
are vlan 123 and vlan 200 transit vlans on the remote site? or are they client vlans?
what unicast routing protocol are you using?
are you using PIM sparse mode?
Hope to help
Giuseppe
02-17-2010 01:35 PM
hi Giuseppe
I created vlan 123 and 200 on destination router . also in destination router I have 1 Fastethernet that i create 4 subinterface over it.
I am using PIM sparse-dense mode
thanks
mike
02-17-2010 11:38 PM
Hello Mike,
may you describe the remote site design?
is something like:
site1 ---- R -------- ATM-E3 ------ R2 ---- vlan123,vlan200 --- switch --- client vlans, receivers here
or
site1 ---- R -------- ATM-E3 ------ R2 ---- vlan123,vlan200
with users in vlan 123 and vlan 200
because this makes the difference
Hope to help
Giuseppe
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: