Configuring IPM 4.1

Unanswered Question
Feb 17th, 2010
User Badges:


     When i am configuring IPM 4.1 for udp jitter operation. i am getting the error message as "Only responder enabled devices permitted for selected operations" , but i have configured the "ip sla monitor responder" command both in source and target devices. I have attached the screen shot of the error message also. Please explain me how to overcome the problem.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Joe Clarke Thu, 02/18/2010 - 09:51
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

You need to make sure your target device is seen as a responder-enabled device by IPM.  If you enabled the responder after adding the device to IPM, delete the device from IPM, and add it again.


This Discussion