Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
441
Views
0
Helpful
1
Replies

Configuring IPM 4.1

akash04lingam
Level 1
Level 1

‎02-17-2010 11:08 PM

Hi,

     When i am configuring IPM 4.1 for udp jitter operation. i am getting the error message as "Only responder enabled devices permitted for selected operations" , but i have configured the "ip sla monitor responder" command both in source and target devices. I have attached the screen shot of the error message also. Please explain me how to overcome the problem.

Labels:
Preview file
387 KB
0 Helpful
1 Reply 1

Joe Clarke
Cisco Employee
Cisco Employee

‎02-18-2010 09:51 AM

You need to make sure your target device is seen as a responder-enabled device by IPM.  If you enabled the responder after adding the device to IPM, delete the device from IPM, and add it again.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents