WRVS4400N Wireless Signal Inconsistency

Unanswered Question
Feb 18th, 2010


I have a WRVS4400N and it basically disconnects everything connected to it on a daily basis and the only way of re-connecting to it, is by switching it off and back on again at the mains.

It is sat behind an orange livebox which acts as the modem; so it's sole purpose it to protect everything connected to it wirelessly and via ethernet.

Connected to the WRVS

2 * laptops, connnected via bg class only

1 * MFC Printer (wired)

1 * Iomega NAS (wired)

Once the connection fails and the notification pops up on the laptops, the 'wireless' led goes out on the WRVS.  I have tried to connect a spare LAN to one of the laptops and it will not re-connect this way either.

This has been going on for around 6 months now.  Any ideas?

Kind regards


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Steven DiStefano Thu, 02/18/2010 - 03:13

Hi Mark,

Can you check to see what firmware are you running an dmake sure you have the latest.

Many of the small business FWs can be linked from this page:


here are the release notes for both V1 and V2 HW models

Cisco WRVS4400N Wireless-N Gigabit Security Router - VPN V1.0 & V1.1

Cisco WRVS4400N Wireless-N Gigabit Security Router - VPN V2.0
mavbritton Sat, 03/06/2010 - 08:33

Hi Steve

Sorry for the late reply, I've recently moved and it's taken two weeks for them to move the broadband over.

I have a 1.1 with firmware .13 running.

Oh and i've had to reset twice already today!

Kind regards



This Discussion