Cucm 7.1(3) End User Roles for BAT

Unanswered Question
Feb 18th, 2010

What Role would i need to add to an end user, to give them rights to import BAT files?

I do not want to give the user full super user rights

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
htluo Thu, 02/18/2010 - 05:47

I'm not sure if there's any pre-built role for this.  But you may built a customized role.

Go to CUCM Admin > User Management > Role > Add New > Choose "Cisco Call Manager Administration".  Then you'll see quite a few privileges begin with "Bulk".

Hope this helps.


c.walsh Thu, 02/18/2010 - 06:48


   thanks for your reply, i was aware that i could create a new Role & apply it through a new user group.

I was trying to find out if which existing admin role would cover BAT.



htluo Thu, 02/18/2010 - 07:00

There's no role *just* covers BAT.

If you don't want to give too much permission to the user, you have to fine tune it yourself.


c.walsh Thu, 02/18/2010 - 07:02

I wasn't looking for a role to just cover BAT!

I wanted to know which existing roles it was included in.

But it is sorted now, i have created a new role/user group & applied it to the user

htluo Thu, 02/18/2010 - 07:04

"CCM Super User" covers BAT if that's what you were asking.  But I guess not. 


This Discussion