Whats the maximum bandwidth supported over a single serial interface?

Unanswered Question
Feb 18th, 2010
User Badges:

I have a customer who is telling me they are driving a single X21 port on a HWIC-2T at 4Mb using in Cisco 1841. I have had a quick look around Cisco's site but can't find anything to confirm or deny my customers claims.

Aggregating serial ports is common practice to achieve greater bandwidths but I'm unaware that these single interfaces can be driven at 4Mb, can anyone shed any light on these claims as to whether it’s even possible? and what the likley configuration detail would be?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Ganesh Hariharan Thu, 02/18/2010 - 08:58
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Member's Choice, February 2016

I have a customer who is telling me they are driving a single X21 port on a HWIC-2T at 4Mb using in Cisco 1841. I have had a quick look around Cisco's site but can't find anything to confirm or deny my customers claims.

Aggregating serial ports is common practice to achieve greater bandwidths but I'm unaware that these single interfaces can be driven at 4Mb, can anyone shed any light on these claims as to whether it’s even possible? and what the likley configuration detail would be?

Hi,


Check out the below link about the HWIC-2T support for synchronus and Asynchronus speed support.


http://www.cisco.com/en/US/prod/collateral/modules/ps5949/datasheet_c78-491363.html


Hope to help !!


Ganesh.H

Jerry Ye Thu, 02/18/2010 - 08:58
User Badges:
  • Cisco Employee,

Not that I am aware of.


Question is does the ISP even allow them to push 4MB across?


Regards,

jerry

Giuseppe Larosa Thu, 02/18/2010 - 09:45
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Keith,


>> I have a customer who is telling me they are driving a single X21 port on a HWIC-2T at 4Mb


one port of the two not both the other is not used.


Hope to help

Giuseppe

k031077b1 Wed, 05/13/2015 - 11:29
User Badges:

I saw somewhere that it actually does here is the link and what it says :

Q. Can the integrated services routers run four HWIC-2T all at 8 Mbps on every port?

A. Yes. The configuration is limited only by the total system throughput and the number of available HWIC slots.

Q. Which routers support these HWICs?

A. These HWICs are supported on the Cisco 1841 and the Cisco 1900, 2800,2900, 3800 and 3900 Series Integrated Services Routers.

Q. Are these HWICs supported on the Cisco 1600, 1700, 2600, 3600, or 3700 Series Integrated Services Routers?

A. No.
 

http://www.cisco.com/c/en/us/products/collateral/interfaces-modules/high...

Seem to me like your customer is accurate. 

Actions

This Discussion