3550 per-packet load balancing

Norberto Salgado · ‎02-18-2010

Hi,

I know that already exist some threads concerning per-packet load balancing, but can someone confirm me if 3550 switches support per-packet load-balancing?

Thank you.

Best regards,

Ganesh Hariharan · ‎02-18-2010

Hi,

I know that already exist some threads concerning per-packet load balancing, but can someone confirm me if 3550 switches support per-packet load-balancing?

Thank you.

Best regards,

Hi,

Catalyst 3550 switch prompt commands are not supported in this release Cisco IOS Release 12.1(19)EA1, either because they are not tested, or because of Catalyst 3550 hardware limitations.

Check out the below link Hope to help

http://www.cisco.com/en/US/docs/switches/lan/catalyst3550/software/release/12.1_19_ea1/configuration/guide/swuncli.html

If helpful do rate the post

Ganesh.H

Edison Ortiz · ‎02-18-2010

but can someone confirm me if 3550 switches support per-packet load-balancing?

No, it does not.

Norberto Salgado · ‎02-18-2010

Thank you to both.

Best regards,

Norberto Salgado · ‎02-19-2010

Hi,

does the 4900 switches support this feature? And any router supports this?

The feature navigator seems to be out dated.

Thank you.

Best regards,

francisco_1 · ‎02-19-2010

I believe the 4900 does not as well.

Fancisco

Edison Ortiz · ‎02-19-2010

Routers support the per-packet load balancing. 4900 is a switch - no support on that hardware.

Norberto Salgado · ‎02-19-2010

Ok, thank you again.

By the way, there is another site beside feature navigator where we can check this kind of questions?

Best regards,

Edison Ortiz · ‎02-19-2010

The documentation for the intended hardware (if it is a switch) - or the IOS documentation (if it is a router)

http://www.cisco.com/cisco/web/psa/default.html