02-18-2010 09:19 AM - edited 03-06-2019 09:46 AM
Hi,
I know that already exist some threads concerning per-packet load balancing, but can someone confirm me if 3550 switches support per-packet load-balancing?
Thank you.
Best regards,
02-18-2010 10:09 AM
Hi,
I know that already exist some threads concerning per-packet load balancing, but can someone confirm me if 3550 switches support per-packet load-balancing?
Thank you.
Best regards,
Hi,
Catalyst 3550 switch prompt commands are not supported in this release Cisco IOS Release 12.1(19)EA1, either because they are not tested, or because of Catalyst 3550 hardware limitations.
Check out the below link Hope to help
If helpful do rate the post
Ganesh.H
02-18-2010 10:39 AM
but can someone confirm me if 3550 switches support per-packet load-balancing?
No, it does not.
02-18-2010 02:20 PM
Thank you to both.
Best regards,
02-19-2010 06:53 AM
Hi,
does the 4900 switches support this feature? And any router supports this?
The feature navigator seems to be out dated.
Thank you.
Best regards,
02-19-2010 07:18 AM
I believe the 4900 does not as well.
Fancisco
02-19-2010 07:28 AM
Routers support the per-packet load balancing. 4900 is a switch - no support on that hardware.
02-19-2010 07:32 AM
Ok, thank you again.
By the way, there is another site beside feature navigator where we can check this kind of questions?
Best regards,
02-19-2010 07:52 AM
The documentation for the intended hardware (if it is a switch) - or the IOS documentation (if it is a router)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide