Can a wet200 wireless bridge be used to connect non-wireless clients to a cisco controller based wireless network?

Unanswered Question
Feb 19th, 2010

In other words, can a wet200 wireless bridge be used af a WGB?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
josruiz Fri, 03/26/2010 - 07:43

In theory this is very possible, however you gona have to manually configure the WET200 with the authentication of  the controller's network, the wet will not recognize the Cisco controller's configuration therefore you have to do this manually...

NOTE: I have never performed a test on this devices, I have read  in one of the Cisco books and it said can be done, but I have never done!!!


This Discussion