Cisco 9032 Encoder

Unanswered Question
Feb 19th, 2010

I have a Cisco 9032 encoder.  I see where to set the IP network information but I don't see where the devices auto-negotiation is set.  My 7609 is set to 100/full hard set.  I'm getting runt errors and I'm wondering is this due to the encoder not being able to do a 100/full.  When the router is set to auto i'm getting 100/half.  I would just like to know for sure if the encoder in fact only can do 100/half.



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion