Cisco 2911 router VSS visio shapes

Unanswered Question
Leo Laohoo Fri, 02/19/2010 - 16:43
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

I don't think Cisco has a priority on this yet.  You can, however, push them.  Go to the download page and if you see the option to put a comment down, you should.  In my expereince Cisco always respond to my comments (negative or positive) in 4 hours or less.

mimeyer Fri, 02/19/2010 - 17:20
User Badges:

Hi --

We have forwarded your request to the individual in charge of producing these images and will reply as soon as we get an answer. There can sometimes be a delay when new products come out. (We like these images too and often must wait ourselves.)

Thanks for raising this issue.



Josh Lowe Tue, 04/13/2010 - 12:32
User Badges:

According to the Stencil Index file on the visio stencil page, the stencils for the 2900 series have already been released in a stencil file called "Routers - Cisco 2900" as of March 10, 2010.  However, this file does not appear in the list of stencils.  Is this just a matter of someone forgot to link to the file after uploading it?  According to the Stencil Index, the file has the following stencils in it:

CISCO2901/K9 (Front)
CISCO2901/K9 (Back)
CISCO2911/K9 (Front)
CISCO2911/K9 (Back)
CISCO2921/K9 (Front)
CISCO2921/K9 (Back)
CISCO2951/K9 (Front)
CISCO2951/K9 (Back)

I'd really like to get my hands on this file, I have some diagrams I need to complete.  Any info would be much appreciated!


Beverly Fannion Thu, 04/15/2010 - 09:58
User Badges:

Cisco Routers 2900 is now posted and contains the f

ront and rear images for the 2911. Scroll to bottom of

page to locate file

Josh Lowe Thu, 04/15/2010 - 14:36
User Badges:

Awesome!  Thanks Bev!

For anyone else looking for the template, they are sorted alphabetically now, so the Router - Cisco 2900 template appears somewhere near the middle, not at the bottom.

Thanks again,


This Discussion