02-19-2010 11:57 AM - edited 03-06-2019 09:47 AM
If yes, what IOS should I use to achieve it?
02-19-2010 11:59 AM
Not supported. NAT is only supported on the 6500 line.
02-19-2010 12:01 PM
No. NAT is not supported on Cat4500 with any Sup engine as of now. The future SUP engines might have this feature.
Cheers,
-amit singh
02-19-2010 12:02 PM
If yes, what IOS should I use to achieve it?
NAT is not supported in 4500 series switches !!
Check out the below link hope that clear.
http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a008011c629.shtml#topic1
If helpful do rate the post
Ganesh.H
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: