02-20-2010 07:33 AM - edited 03-15-2019 09:30 PM
Hello Guys,
I have a lab setup with 2 2621XM routers with VWIC-1MFT-T1 1-Port Multiflex Voice Cards in them with a crossover cable between the devices. When I go under the controller interface below to use the PRI_GROUP or DSO-GROUP commands they are not available. I only see why what is listed below. Why is that?
VoiceGateway(config)#controller t1 0/1
VoiceGateway(config-controller)#?
Controller configuration commands:
cablelength Specify the cable length for a DS1 link
channel-group Specify the timeslots to channel-group mapping for an
interface
clock Specify the clock source for a DS1 link
crc-threshold Specify how many CRC errors per second to be treated as
severely errored second (SES)
default Set a command to its defaults
description Controller specific description
detect Enable detection of loopback request
exit Exit from controller configuration mode
fdl Specify the FDL standard for a DS1 data link
framing Specify the type of Framing on a DS1 link
guard-timer Guard timer (0-20) for xcsp calls - timer duration and
accept/reject on expiry
help Description of the interactive help system
linecode Specify the line encoding method for a DS1 link
loopback Put the entire T1 line into loopback
mode Configure the controller mode
no Negate a command or set its defaults
shutdown Shut down a DS1 link (send Blue Alarm)
02-20-2010 07:54 AM
You need either an AIM DSP, or NM-HDV-xxx
No DSP, no voice ports.
02-20-2010 08:15 AM
Is there anything I need to do in order to get my card to use the DSP's on the Module?I do have a Cisco NM-1V Voice Network Module VIC in that router but, do not have card plugged in that slot. I have it inserted in regular slot. Do I need to config my controller to use those DSP's on the module or something?
02-20-2010 01:21 PM
That does support VWIC.
Must use HW indicated above.
02-20-2010 01:50 PM
I looked at the cost of the DSP's can not afford them to run the VWIC'S I
purchased. Is the any cards that I can buy that will work with the equiptment I told you I have? Maybe there are PRI cards that I can purchase to get the training I need for DSO-GROUPS and PRI-GROUPS.
02-21-2010 04:28 AM
Check the popular auction site for savings.
Please rememeber to rate useful posts clicking on the stars below.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: