Do E1 need always CCS or CAS ?

Unanswered Question
Feb 21st, 2010
User Badges:

Hi, Please help me.
I have to implement VoIP using MPLS like following.

PBX-A---(E1)---Cisco2811---MPLS---Cisco3725---(E&M)---PBX-B

I need to configure Cisco2811 and need to ask PBX-A vendor to add E1 card  and configuration to PBX-A.
Should I pay attention to CCS ( or CAS ) between PBX-A and Cisco2811 ?
Does It has nothing to do with this case ?

(FYI)

controller E1 1/0
framing crc4
clock source line       
linecode hdb3
ds0-group 1 timeslots 1-8 type e&m-wink-start

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Sun, 02/21/2010 - 14:02
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Ask for ISDN PRI (CCS).

moonviewingjp Mon, 02/22/2010 - 02:59
User Badges:

Thank you for your commnet. I really appreciate your answer.


Does it mean DS0 signaling require CCS ?


According to folloing URL, NM is available for both CCS and CAS.

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a008039c333.shtml

Could you give me the refelence URL in detail which provide information regarding  CCS required under this case?

I am really confused.

paolo bevilacqua Mon, 02/22/2010 - 08:13
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

2811 does not require NM, use VWIC and PVDM2 directly.


It would be better if you engage a voice network engineer for the project, because if you have no experience it will take much time and errors for you to get it right.

Actions

This Discussion