02-22-2010 10:44 AM - edited 03-18-2019 11:06 AM
Hi All,
I am using CUCM 7.1. When I dial international number then press pound key to bypass T302 timer, I receive busy tone. But when I wait for 15 sec, the call is successful. is there any service parameter in CUCM to allow dialing # key to make a call immediately?
thanks
Alex
Solved! Go to Solution.
02-23-2010 05:39 AM
U have to create another route pattern with 9.!#
02-22-2010 10:53 AM
Why don't you change interdigit timeout to 3 or 4 seconds like most people do ?
02-22-2010 10:58 AM
thanks for your response. But I need to use #, since most people get used to it.
02-22-2010 11:09 AM
I think a good installation has both reasonable timeout, and pound termination.
Then, some countries use fixed lenght numbers, that you can configure if dialed frequently.
02-22-2010 12:02 PM
Hi, just a suggestion, do you have a route pattern with the # symbol at the end, for example: 9.!#
hth
David
02-23-2010 05:39 AM
U have to create another route pattern with 9.!#
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: