Using "set span" with CAT OS on 4006

Unanswered Question
Feb 25th, 2010


I need to monitor network traffic going through a 4006 switch running CAT OS.  All traffic is on VLAN 1. I have a port sniffer PC setup and connected to two ports on this switch, the sniffer is on port 6/2,  I want to direct all traffic through this port so it can be monitored. So far I have not been able to make it work.  I have the following code in place but it is not working:

switch port analyzer

set span 1 6/2 both inpkts enable learning enable create

Let me know if you need the entire config posted.  Anyone have ideas?



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion

Related Content