I have a cisco catalyst 3020, and am in the process of attempting to set up IPv6 stateless DHCP.
The 3020 is configured as follows:
sdm prefer dual-ipv4-and-ipv6 vlan
g0/19 : switchport access vlan 2
g0/17 : switchport access vlan 13
g0/11 : switchport mode trunk
The other router (which I cannot access / configure), f0/15 is (based on a network diagram), configured to vlan 2, no inbound acl, outbound acl 141, a xxxx:xxxx:x:x:: /64 prefix, and configured for IPv6Stateless DHCP.
Sadly beyond this I'm already getting lost:
The intent is to configure g0/11 to have IPv4 off vlan 13, and IPv6 off vlan 2, and to use those vlans in managing networks within vCenter4.
If this is not possible, I would greatly appreciate the heads up.
As an alternative, would I be able to pass the vlan 2 from g0/19 to g0/11, and then configure things within a vmware distributed switch / virtual network configuration where I have more control?
Thank you for any insight,