cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
400
Views
0
Helpful
2
Replies

reg: fxs config

vasuramnet
Level 1
Level 1

Dear sir,

Iam trying for small lab setup i have cisco 2800 series router in that i have 2port FXS
cord is there now my set up is

I connected router G0/0 to PBX ethernet port in that pbx i have ip gateway cord now iam
trying to configure the router in such a way that iwant to call from gateway card through
FXS and from FXS to gate way cord.

Both sides i have to send a call and receive a call .In this senario how can i configure
the router FXS ports to send/receive calls.

plz help me in this config

Thanks&Regards
srinivas
9246571397

2 Replies 2

mansoor2000
Level 1
Level 1

On the 2800 router, have you setup dial-peers and pointed them to the PBX?

What PBX are you connecting to your 2800 router?

Here is an expamle of a dial-peer.

dial-peer voice 1 pots
description POTS incoming dial-peer
incoming called-number .
direct-inward-dial

dial-peer voice 100 pots
destination-pattern 1000
port 0/3/0

Hi Mansoor Ahmed,

Thanks for ur reply and in ur config there is no session targer weather i have to give session target also

My set up is -----

   analog phone---------------PBX(ip pbx)-----------------router(2800)---fxs(2port)------analog phone

Is there any sample config

srini

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: