Low Level Elevator Security Interface with Physical Access Control

Unanswered Question
Feb 26th, 2010

Hi,

We have an existing access control system that we are looking to replace with the Cisco solution.  Part of the current system is elevator access control.

This has a reader in each elevator car and a relay card that has one relay for each of the six access controlled floors.  These relays close a circuit that is supplied from the elevator control system.

I am wondering how I can acheive this integration using the Cisco solution. Ideally we would be able to control access to each floor individually, but I am not sure how to have a single reader associated with what is effectively six different 'doors'.

Thanks,

  Paul

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
galaxyct1 Wed, 03/03/2010 - 21:01

It can be done with some creativity using I/O rules with an output module attached to an access gateway.

Please contact me offline to discuss further.

Thanks,

Ben

Actions

This Discussion