dhcp for vlan no native from Catalyst 2950

Unanswered Question
Feb 27th, 2010
User Badges:

Hi ,

I have two vlans and there is an dhcp server for

hosts ip of vlan 1.

Can I distribute ip address in vlan 2 which is

no native on my network from an Catalyst 2950 ?

Does anyone advice my an a configuration example

or document about ?

Best regards

Lorenzo

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Ganesh Hariharan Sat, 02/27/2010 - 22:49
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Member's Choice, February 2016

Hi ,

I have two vlans and there is an dhcp server for

hosts ip of vlan 1.

Can I distribute ip address in vlan 2 which is

no native on my network from an Catalyst 2950 ?

Does anyone advice my an a configuration example

or document about ?

Best regards

Lorenzo

Hi Lorenzo,


DHCP configuration in 2950 switches can be done by following commands check out the below link hope that help and if you want a dhcp request to be forwarded to other vlan or in other interface then you need to use ip helper address check out the link for configuring the same also.


http://www.cisco.com/en/US/docs/switches/lan/catalyst2950/software/release/12.1_19_ea1/configuration/guide/swipaddr.html#wpxref74213


http://cisconet.com/tcpip/dhcp/107-how-to-use-ip-helper-address-to-connect-remote-dhcp-server.html


Hope to Help !!


If helpful do rate the post


Ganesh.H

Actions

This Discussion