We have an ASA 5540 failover bundle working in Active/Standby mode. On our active asa 5540 when the sh run command is issued it gets stuck and displays the output after more than 15-20 mins.. and it takes another 10-15 mins to get back to the prompt..
However on the standby asa 5540 if the sh run command is issued, it displays the ouput and comes back to the prompt (even though this also takes 2-3 seconds)
I have tried rebooting the active asa 5540, but still the same issue.. what could be the problem?? any inputs pls...
We are running asa version 8.2.2
No.. I dont think it will impact our network/security monitoring and in my past and current experience in enterprise network we used to configure in syslog trap in warning level.
We used to monitor resource utilization and any normal/abnormal connection status or attacks. To monitor these syslog warning level is more than enough.
Hope it helps you