03-03-2010 06:29 AM - edited 03-15-2019 09:36 PM
Hi All
Having issues registering the N97 to the CUCM, can anyone point me in the right direction or provide steps neccesary.
Much Appreciated...
Shaun
03-03-2010 07:36 AM
Hi Shaun
I'm guessing you are trying to get this working using SIP?
Take a look at this old post:
Regards
Aaron
Please rate helpful posts...
03-04-2010 12:00 AM
Hi Aaron
Thanks for the post. Perhaps I should post what has been configured, maybe it'll help me see where I went wrong by seeing it once all the config is written down.
On the CUCM 6 side:
I have created:
On the Nokia N97:
I have also tried using public username: sip:0621@172.21.34.163
Although today the phone just says: Not registered and not registration failed. On CUCM side, state uis Unknown.
Do you think it could be because the realm is not 'ccmsipline' (CUCM default) on both the SI Phone and the SIP Realm (I don't think it matters if you create your own SIP Realm) - I saw a guy having this issue with his integration on the forum relating to your previous posts.
I'm going to restart the phone now and check again if it works... can you see anything wrong here?
Thanks for the great posts
03-07-2010 11:11 PM
Hi Aaron / NetPro's
I have checked all settings as above and gone through the older post as suggested by you, however still getting registration failed.
Is there something I'm missing? I upgraded to the latest firmware on the N97, in case of a software issue, but as I say I still get the same problem.
Any ideas?
03-10-2010 01:36 AM
Got it Working, everything is the same as above, public username must be your DN (0621) and make sure in the proxy server and registrar server your username (as configured in CUCM ) is exactly as it appears, it is CASE SENSATIVE.
Other than that if you go to service parameters in CUCM you will see the SIP Realm (Even if you configure your own under user management) is set to ccmsipline, so make sure you use this realm when configuring your SIP Phone. You do not need to create one under end user. If you want to change this default ccmsipline change it under service parameters for the publisher server.
Hope this helps everyone else!!!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: