NAT redundancy on 6500

Unanswered Question

I can see it is easy to configure IP NAT redundancy on 3700, 7000 series devices, but how do I configure it on a 6500 series switch ??


The other systems basic command is  ip nat inside source static 1.1.1.1 .2.2.2.2  redundancy hsrp1  then you associate this with the standby interface.


This last entry cannot be entered on the 6500 ??


Any ideas ?



Thanks for any info.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Reza Sharifi Thu, 03/04/2010 - 07:00
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 LAN

Hi Martin.


It looks as this command has been modified



12.2(4)T

This command was modified to include the ability to use route maps with static translations, and the route-map name keyword and argument combination was added. This command was modified to include static translation with Hot Standby Routing Protocol (HSRP), and the redundancy group-name keyword and argument combination was added. This command was modified to enable the translation of the IP header address only, and the no-payload keyword was added.


Here is command reference guide:


http://www.cisco.com/en/US/docs/ios/ipaddr/command/reference/iad_nat.html#wp1041067


HTH

Reza

Actions

This Discussion