cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4308
Views
0
Helpful
5
Replies

PLAR on VG224

aeriksson
Level 1
Level 1

Hi!

Does any one has a sample config for PLAR on a VG224?

I have followed this guide,but suspect I need some config in the VG as well,

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a0080232b9f.shtml#Steps1

5 Replies 5

Aaron Harrison
VIP Alumni
VIP Alumni

Hi


Are you running H.323 or MGCP on your VG?

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

Hi! It is H323. regards Annika

Hi

THe document you saw really refers to MGCP, where all the dial plan stuff is controlled by CCM.

As you are H.323, you need to enter this command on the voice-port :

connection plar xxxx

Where xxxx is the number you want to dial.

Regards

Aaron

Please rate helpful posts...    

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

Sorry I was totally wrong. The VG224 is set up in SCCP-mode. Not H323 as I wrote before.

No additional configuration needs to be performed on the VG224 assuming the VG224 is working properly otherwise.

If you follow the Cisco instructions and are having issues, you may need to add the partition of the destination DN to the calling search space, not just the newly created autodial partition.

Hope that helps.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: