03-05-2010 03:29 AM - edited 03-04-2019 07:42 AM
Hi,
6506 is running CAT OS and I need to upgrade the software to IOS. On CAT OS the switching module and routing module are on different session.
My question
(1) After upgrade wil I get single session to manage switching & routing module
(2) on CATOS we got LACP configured ; is any modification needed on it
(3) Any Change in configuration is needed for Two SUP
Anything else to watch out before the upgrade.
Thanks
ST
Solved! Go to Solution.
03-05-2010 03:42 AM
Hello Saquib,
you need to follow the procedure for CatOS to IOS conversion
you need to do it two times one for each supervisor /MSFC
so your first step is to remove one sup convert the remaining sup, then you will remove the converted supervisor and you will insert the other one alone and you will perform conversion again for the second supervisor.
At the end you will insert first sup again and you should be able to get one active and the other standby in native mode
at the end you will get a single session to access the device
(2) on CATOS we got LACP configured ; is any modification needed on it
LACP is supported on IOS too but you need to configure it. By the way the device needs to be configured.
There is a config conversion tool but it is not recommended.
http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015bfa6.shtml
follow the document step by step depending on your sup model
HW and SW requirements are listed
it will take some time (hours)
Hope to help
Giuseppe
03-05-2010 03:42 AM
Hello Saquib,
you need to follow the procedure for CatOS to IOS conversion
you need to do it two times one for each supervisor /MSFC
so your first step is to remove one sup convert the remaining sup, then you will remove the converted supervisor and you will insert the other one alone and you will perform conversion again for the second supervisor.
At the end you will insert first sup again and you should be able to get one active and the other standby in native mode
at the end you will get a single session to access the device
(2) on CATOS we got LACP configured ; is any modification needed on it
LACP is supported on IOS too but you need to configure it. By the way the device needs to be configured.
There is a config conversion tool but it is not recommended.
http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015bfa6.shtml
follow the document step by step depending on your sup model
HW and SW requirements are listed
it will take some time (hours)
Hope to help
Giuseppe
03-05-2010 04:12 AM
Giuseppe Thanks
You are alwayz a great help :-)
I will follow as you recommended.
Ganesh thanks as well.
03-05-2010 03:43 AM
Hi,
6506 is running CAT OS and I need to upgrade the software to IOS. On CAT OS the switching module and routing module are on different session.
My question
(1) After upgrade wil I get single session to manage switching & routing module
(2) on CATOS we got LACP configured ; is any modification needed on it
(3) Any Change in configuration is needed for Two SUP
Anything else to watch out before the upgrade.
Thanks
ST
Hi ST,
Check out the below link hope it help !!
http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a0080816fbc.shtml
Ganesh.H
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: