03-05-2010 04:05 AM - edited 03-04-2019 07:42 AM
I cannot get inline adapter to work, on wae-512. lan port of inline groups is admin down
was#sh int inlineport 1/0/lan
Device name : eth5. Bypass slave interface.
Packets Received : 0
Packets Intercepted: 0
Packets Bridged : 0
Packets Forwarded : 0
Packets Dropped : 0
Packets Received on native : 0
Active flows for this interface : 0
Ethernet Driver Status
-------------------------
Type:Ethernet
Ethernet address:00:E0:ED:10:D0:B7
Maximum Transfer Unit Size:1500
Metric:1
Packets Received: 0
Input Errors: 0
Input Packets Dropped: 0
Input Packets Overruns: 0
Input Packets Frames: 0
Packet Sent: 0
Output Errors: 0
Output Packets Dropped: 0
Output Packets Overruns: 0
Output Packets Carrier: 0
Output Queue Length:1000
Collisions: 0
Base address:0x40c0
Flags:BROADCAST MULTICAST
Link State: Interface is administratively down, line protocol down
Mode: autoselect
was#
08-27-2010 10:26 PM
I have this same problem... where you able to solve this issue? My interface is on a trunked interface.
08-29-2010 10:07 PM
you must have connected and alive both ports in grou
p, wan and lan. In my case error was that I connected only wan port.
bye
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: