LMS3.1/RME: inventory report

Unanswered Question
Mar 5th, 2010
User Badges:

Hi,

I would like to get an information about gigaStack port on switch inventory.

I have generated an Detail device Report but I didn't get this information.

I can find this information by show interface status | include GigaStack on switch :

Gi0/1                        connected    trunk      a-full a-1000 1000BaseCX Gigastack

Gi0/2                        connected    trunk      a-full a-1000 1000BaseCX Gigastack


So, I try with RME -> Tools -> Netshow. see file attached.


I get the information but I prefered to get it in with a report because I need to get thoses informations for 150 devices.

Is there a way to get it on a report ?


When I look at RME->Admin-> Inventory-> Change Filter,

I think that there are more port information compare to report generator.

Status


Parent Relative Position


Port Interface Index


Operational Status


Manufacturer Name


Field Replaceable Unit


Alias Name


Slot Configuration


Port Model Name


Port Vendor Type


Power Remaining


Port Serial Number


Power Consumption(%)


Description


Power Consumption


Component Type


Power Available


Port Index


Power Allocated


Maximum Power


POE Admin Status


Physical Entity Name


Custom report, port attribute, I can take only thoses attributes:


Maximum Power

Power Allocated

Power Available


Power Consumption

Power Consumption(%)

Power Remaining

POE Admin Status


Why there are more infiormation for change audit than inventory report ?


Thanks, Elisabeth

Inventory Change Filter : Port 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Joe Clarke Fri, 03/05/2010 - 11:55
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

I have a bug open to make sure all of the inventory attributes seen in the Detailed Device Report are also available for custom reports (CSCsj78780).  Quite a few were added in RME 4.3, but the list is still not complete.


As for Netshow, there is no way to change the output format type (i.e. you cannot make it more like the inventory reports).  However, you could perhaps write a script to parse the CLI output from Netshow, and deliver a report in the desired format.

ebezombes Fri, 03/05/2010 - 13:16
User Badges:

Do you think that there is an attribute or an snmp variable for GigaStack information like I can get with show status ?


Port      Name               Status       Vlan       Duplex  Speed Type

Gi0/1                        connected    trunk      a-full a-1000 1000BaseCX Gigastack

Gi0/2                        connected    trunk      a-full a-1000 1000BaseCX Gigastack




Joe Clarke Sat, 03/06/2010 - 06:54
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

I don't think so, but I do not have a 3750 with a Gigastack GBIC with which to test.  If this data is available in RME, it would be visible in the Detailed Device Report.  However, I think the type attribute will only indicate it is an ethernet port.

Actions

This Discussion