03-05-2010 11:42 AM
Hi,
Customer wants to upload image D1246T.SPS for 2610XM, but it failed I think that image name is not reconize by LMS, is there a way to change image name file as a workaround ?
Thanks, Elisabeth
03-05-2010 11:52 AM
If it's not an system image (or certain type of modem firmware), then SWIM cannot handle it. You could, however, use Netconfig to perform a TFTP copy of the file from a network server. This will be interactive, so be sure to use the interactive notation when defining the job. For example:
copy tftp://10.1.1.1/D1246T.SPS flash:
Or whatever the prompts may be in your case.
03-09-2010 01:11 AM
Hello Joe,
On the command given:
copy tftp://10.1.1.1/D1246T.SPS flash:
Richard
03-09-2010 10:41 PM
It means, "response to follow." What comes after is the response to an interactive prompt.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: