CF NOAN and SNR issue

Unanswered Question

Ever since I upgraded to 8.0.1 my SNR and Call Forward no answer does not work.

When i enable SNR and call the primary or secondary number (config attached) it just rings and rings and never goes to the UC VM.  Depite the fact that the SNR timeout is set to 14 it continues to ring my mobile beyond the 14 seconds in the backgrand and leaves a 3 second empty voicemail on my mobile VM even though the the line is never conencted to the origonal calling party.

On the first SNR attempt the caller id displayed on my mobile is the main number as it should be becouse the UC520 is calling me to relay the call.  However if I continue to let it ring for say a minute or more (long after the CF noan should have sent the call the the UC520's VM)  my mobile phone rings again, this time with the caller id of the origonal calling party.  This is very odd!  So the UC520 is relaying the Caller ID information of the calling party through the system on a second SNR attempt.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Marcos Hernandez Sun, 03/14/2010 - 17:47
User Badges:
  • Blue, 1500 points or more

Hi Dave,

Can you please provide a "debug voip ccapi inout" for a failed SNR call?




This Discussion