Need to verify OER and PFR

Answered Question
Mar 9th, 2010

H  i  ...

I have configured PFR between hub & spoke site , applicaiton server is at hub location & client is on spoke site .

both sites have one MC/BR and one BR router . How can i verify pfr is working fine .show command outputs for MC and BR attached for ref .

thnx

madu

Attachment: 
I have this problem too.
0 votes
Correct Answer by Steve Lyons about 5 years 11 months ago

Hello,

We have a PfR troubleshooting document which I would recommend for review:

http://docwiki.cisco.com/wiki/PfR:Troublehooting:System

Once you have verified the operation of the PfR system then you can issue the following commands:

show oer master policy - provides information on your configured policy settings.

show pfr master policy  - same command however in newer code it was changed to keyword pfr.

show oer master prefix - provides information on prefixes that have been learned.

show pfr master prefix  - same command however in newer code it was changed to  the keyword pfr.

If you have any further questions please let me know.

Best Regards,

Steve Lyons - Cisco

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Steve Lyons Wed, 12/08/2010 - 19:45

Hello,

We have a PfR troubleshooting document which I would recommend for review:

http://docwiki.cisco.com/wiki/PfR:Troublehooting:System

Once you have verified the operation of the PfR system then you can issue the following commands:

show oer master policy - provides information on your configured policy settings.

show pfr master policy  - same command however in newer code it was changed to keyword pfr.

show oer master prefix - provides information on prefixes that have been learned.

show pfr master prefix  - same command however in newer code it was changed to  the keyword pfr.

If you have any further questions please let me know.

Best Regards,

Steve Lyons - Cisco

Actions

This Discussion