Wifi bridge stops responding to ping

Unanswered Question
Mar 10th, 2010
User Badges:

Hello everybody,

I have six  1310 wifi bridges in star topology. Everything was ok, but yesterday all bridges stops responding to ping, and it is not possibel to access them remotely. Bridges are accessible only from local subnet, from computers behind them.  But traffic is still passing through, all computers are reachable from remote sites.

Just one spoke bridge was reloaded during night, but it didn`t helped.

I think, that hub bridge reload should fix this issue, but any idea why it happen?

P.S. I had same issue with 1841 router in past. It had same IOS, HW, config (just diffrerent IP adresses, spaces) like others branch offices, but just this one had similar problems like bridges above. Only RMA fixes this problem.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Scott Fella Wed, 03/10/2010 - 05:08
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

I have seen that in the past with other bridges.... reboot of the root bridge fixes that issue, but is only a work around.  Maybe open a TAC case and see.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode