ā03-11-2010 02:57 AM - edited ā07-03-2021 06:36 PM
Hi
I was reading through the Admin Guide for Cisco Unified Communications Manager 7.0(1) for the Cisco 7925G Wireless Phone and discovered that if you select the Authentication Type on the Phone as EAP-FAST then it supports WEP and TKIP. I was wondering if it does not support this mode with AES and if so has anyone run this deployment?
I ask this because I have deployed this and notice that we get numerous Authentication Failures and Errors on the phones and they lock up periodically with a message;
Authentication Failed!
Your user credentials may be incorrect
Profile: Profile 1
When I enter the new original password for the account it still does not authenticate.
As a test I have also run a new SSID with EAP-FAST and TKIP and I get no such problems
Regards
Greg
Solved! Go to Solution.
ā03-11-2010 12:46 PM
Yes, they support AES. Try configuring the phone for AKM. Keep in mind that CCKM with AES is not supported until 1.3.4.
ā03-11-2010 01:03 PM
Using 1.3.4 with WLC firmware 6.0.196.0. I've enabled WPA2 with AES and works pretty good!
ā03-11-2010 12:46 PM
Yes, they support AES. Try configuring the phone for AKM. Keep in mind that CCKM with AES is not supported until 1.3.4.
ā03-11-2010 01:03 PM
Using 1.3.4 with WLC firmware 6.0.196.0. I've enabled WPA2 with AES and works pretty good!
ā03-31-2010 01:55 AM
Hi
I have upgraded the phones to 1.3(4) and this resloves the error message I received on the phones. I was aware of that CCKM was not supported with AES but following the upgrade all is good.
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide