I have 2 ASA 5520's set up in an Active/Standby scenario. The link between them is but a mere cross-over cable. The failover works fine. it fails over and picks up without missing a beat. My question is....if the primary fails over to the secondary, should I still be able to use ASDM to manage the ASA? Is ASDM supported on the secondary ASA when its active?
Reload will fix it or you can toggle the "http server enable" line as well. It will complain that you are trying to make change on the standby unit but just do it and then issue "sh asp table socket" again.
We are very close....
By saying toggle I mean issue a "no http server en" and then "http server en"