03-14-2010 08:22 AM - edited 03-06-2019 10:07 AM
Hi,
I am facing problem with cisco catlayst 2960 switch
cisco catalyst with ios ver 12.12(52) SE is configured 3 vlans (1,200,100) .Siwtch port gigabit Ethernet 0/24 is configured as trunk connecting the cisco 2821 (ios ver 12.4(15) T3 ) gigathernet 0/0 port of the router.
vlan 1(management vlan)-192.168.10.0/24
vlan 200(Data)- 192.168.1.0/24
vlan 100(voice)- 192.168.11.0/24
vlan 200 is configured as native on both switches
when i am configuring any switch port connecting to PC under any of the vlan mentioned above ,I am able to ping router from pc but from router i am not able to ping pc
what can be the reasons for switch behaving like this
Solved! Go to Solution.
03-14-2010 09:27 AM
Hello Praveen,
Do you have any firewall software installed on your PC that prevents it from being pinged?
Can you try pinging a different PC?
HTH
Reza
03-14-2010 09:49 AM
Praveen
As Reza said, it could well be firewalls on the PCs. From a PC in vlan 100 can you ping the vlan 200 IP address on the router ? If so this would strongly suggest a personal firewall issue.
Jon
03-14-2010 09:10 AM
Hi,
Please post the configuration of the Router and the Switch.
Thanks & Regards
Zeeshan Sanaullah
03-14-2010 09:27 AM
Hello Praveen,
Do you have any firewall software installed on your PC that prevents it from being pinged?
Can you try pinging a different PC?
HTH
Reza
03-14-2010 09:49 AM
Praveen
As Reza said, it could well be firewalls on the PCs. From a PC in vlan 100 can you ping the vlan 200 IP address on the router ? If so this would strongly suggest a personal firewall issue.
Jon
03-14-2010 09:55 PM
Thanks Everyone supporting me
It was the antivirus in the PC which is blocking ICMP packets.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: