configure UCM with SIP account

Unanswered Question
Mar 14th, 2010

Hi ,
Can someone guide me whom have experience with configure SIP account from SIP Provider with Cisco Voice Gateway, the idea is to point UCM users to point for all International calls to pass via Cisco Voice Gateway router then ------INTERNET -----SIP Provider :
Here is my SIP user account configuration:

sip-ua
authentication username 1777XXXXXXX password XXXXX
no remote-party-id
retry invite 4
retry response 3
retry bye 2
retry cancel 2
retry register 5
timers register 250
mwi-server ipv4:204.11.192.36 expires 3600 port 5060 transport udp unsolicited
registrar ipv4:204.11.192.36 expires 3600
sip-server ipv4:204.11.192.36

Regards,

SID

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
gogasca Sun, 03/14/2010 - 21:17

In CUCM create a route pattern and point it to the Cisco VGW using

a SIP trunk

In GW just create your dial-peers to point to the SIP Provider

sidris-sid Sun, 03/14/2010 - 22:41

already I configure all what you have mentioned .....I forget to mentioned it..... should i contact SIP Provider maybe from their side …..i test the account with SIP software its working fine, what about if i used NATed IP address would find with me......or i need to got public IP Address for voice Gateway.

Your advices.

regards,

SID

Actions

This Discussion