Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
556
Views
0
Helpful
2
Replies

configure UCM with SIP account

sidris-sid
Level 1
Level 1

‎03-14-2010 01:10 PM - edited ‎03-15-2019 09:46 PM

Hi ,
Can someone guide me whom have experience with configure SIP account from SIP Provider with Cisco Voice Gateway, the idea is to point UCM users to point for all International calls to pass via Cisco Voice Gateway router then ------INTERNET -----SIP Provider :
Here is my SIP user account configuration:

sip-ua
authentication username 1777XXXXXXX password XXXXX
no remote-party-id
retry invite 4
retry response 3
retry bye 2
retry cancel 2
retry register 5
timers register 250
mwi-server ipv4:204.11.192.36 expires 3600 port 5060 transport udp unsolicited
registrar ipv4:204.11.192.36 expires 3600
sip-server ipv4:204.11.192.36

Regards,

SID

Labels:
0 Helpful
2 Replies 2

gogasca
Level 10
Level 10

‎03-14-2010 09:17 PM

In CUCM create a route pattern and point it to the Cisco VGW using

a SIP trunk

In GW just create your dial-peers to point to the SIP Provider

0 Helpful

sidris-sid
Level 1
Level 1
In response to gogasca

‎03-14-2010 10:41 PM

already I configure all what you have mentioned .....I forget to mentioned it..... should i contact SIP Provider maybe from their side …..i test the account with SIP software its working fine, what about if i used NATed IP address would find with me......or i need to got public IP Address for voice Gateway.

Your advices.

regards,

SID

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents