03-14-2010 01:10 PM - edited 03-15-2019 09:46 PM
Hi ,
Can someone guide me whom have experience with configure SIP account from SIP Provider with Cisco Voice Gateway, the idea is to point UCM users to point for all International calls to pass via Cisco Voice Gateway router then ------INTERNET -----SIP Provider :
Here is my SIP user account configuration:
sip-ua
authentication username 1777XXXXXXX password XXXXX
no remote-party-id
retry invite 4
retry response 3
retry bye 2
retry cancel 2
retry register 5
timers register 250
mwi-server ipv4:204.11.192.36 expires 3600 port 5060 transport udp unsolicited
registrar ipv4:204.11.192.36 expires 3600
sip-server ipv4:204.11.192.36
Regards,
SID
03-14-2010 09:17 PM
In CUCM create a route pattern and point it to the Cisco VGW using
a SIP trunk
In GW just create your dial-peers to point to the SIP Provider
03-14-2010 10:41 PM
already I configure all what you have mentioned .....I forget to mentioned it..... should i contact SIP Provider maybe from their side …..i test the account with SIP software its working fine, what about if i used NATed IP address would find with me......or i need to got public IP Address for voice Gateway.
Your advices.
regards,
SID
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide