cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
621
Views
0
Helpful
2
Replies

Devices steel in learning mode in DFM LMS 2.5

Peter_Setaffy
Level 1
Level 1

Hallo

I have also the problem.
All my device steel in learning mode.

This is my version LMS:
LMS 2.5


CiscoWorks Common Services 3.0.3
Campus Manager 4.0.3
CiscoView 6.1.2
Device Fault Manager 2.0.3
Integration Utility 1.6.0
Resource Manager Essentials 4.0.3

I try to change the poling configuration in DFM and I received this message.

Could not retrieve current data since the PTMServer process is down.

Please restart the process and perform this operation again.

But the PTMServer is running

thanks

2 Replies 2

Peter_Setaffy
Level 1
Level 1

Joe Clarke
Cisco Employee
Cisco Employee

LMS 2.5.1 is very old, and will no longer be supported after June of this year.  I strongly suggest you upgrade to LMS 2.6 with DFM 2.0.13 before going further.  LMS 2.6 can be downloaded from http://tools.cisco.com/support/downloads/go/Redirect.x?mdfid=268439477 , the Common Services 3.0.6 update (to be applied after 2.6) from http://www.cisco.com/cgi-bin/tablebuild.pl/cd-one-3des , then DFM 2.0.13 can be found via Common Services > Software Center > Software Update.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: