BGP

ccie_rooky · ‎03-16-2010

When I run sh run on the router, I don't any information about BGP at all in the output. However, when I run sh IP bgp..., I can see the IBGP and EBGP information. I have security level of 15. Any reason why the 'show running config" does not include BGP info?

Tharak Abraham · ‎03-16-2010

Hi,

Is that only for BGP config or is it the same for IGP too ?

try "sh run | section bgp" or "sh run | begin bgp" or "sh run | in router bgp" et al...just curious..-:)

ccie_rooky · ‎03-16-2010

It is for both IBGP and EBGP. Nothing shows at all.

KARUPPUCHAMY MALAIYANDI · ‎03-16-2010

Hi,

run the below command , you will get all the BGP config info

#sh run | b r bgp

Regards

Karuppu

ccie_rooky · ‎03-17-2010

Thanks for your help. But why

the BGP info doesn't show up if I don't use the output modifier?

Thanks.

John Blakley · ‎03-17-2010

You may want to look at updating the IOS. I seem to remember someone else on here having the same issue until they updated. What type of equipment are you running and IOS version?

John

HTH, John *** Please rate all useful posts ***