Configure site-to-site VPN with CCP

Answered Question
Mar 17th, 2010
User Badges:

Hi,


I have several site-to-site VPNs from small offices, to the main office.

Is possible to do a single configuration for all the VPNs on the "vpn server"(ISR 1801) or I always need to add a entry for each VPN subnet? If so, is possible with CCP?


Regards,

Nuno

Correct Answer by Federico Coto F... about 7 years 1 week ago

You can configure then VPNs using CCP.


I prefer the command line, and if there are many Site-to-Site VPNs, you can have a template, and all that changes from one VPN to another is the interesting traffic, the peer IP and the pre-shared key.


This depends on the policies.


Federico.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Federico Coto F... Wed, 03/17/2010 - 10:18
User Badges:
  • Green, 3000 points or more

You can configure then VPNs using CCP.


I prefer the command line, and if there are many Site-to-Site VPNs, you can have a template, and all that changes from one VPN to another is the interesting traffic, the peer IP and the pre-shared key.


This depends on the policies.


Federico.

nunojpg00 Wed, 03/17/2010 - 11:16
User Badges:

Thanks for your answer. I guess that templates are out of bound for CCP...


You prefer the command line? I would say you configure cisco routers more than once a year


CCP is a terrible software but makes cisco routers usable to someone that only wants to configure a router once in is life.


Regards

Actions

This Discussion