Display of Parked Call Extension

Unanswered Question

Is there a way to configure the parked call extension to stay on the phone display longer or until the next phone action?  I think our settings is about 5 seconds and sometimes people forget where the call was parked or forget to make a note of it.  We are using a UC560 with SPA504G phones.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Jaime Valencia Thu, 03/18/2010 - 12:42

You can't modify that, however you can tweak the reminders to make sure they know of the parked calls.



timeout seconds

(Optional) Sets the call-park reminder timeout in seconds.  Range: 0 to 65535. This reminder sends a 1-second ring to the IP phone  that parked the call and displays a message on the LCD panel of all  phones in the Cisco Unified CME system, indicating that a call is on  hold. By default, the reminder ring is sent only to the phone that  parked the call.

limit count

(Optional) Sets a limit on the number of reminder or retry timeouts.  Range: 1 to 65535.



If this helps, please rate



This Discussion