Need solution

Unanswered Question
Mar 18th, 2010
User Badges:

Hi,


Here is the requirement:


I  have three locations(A,B,C).. Now I looking tunnel redundency.


A -- B one tunnel(this should be always primary)

A - C on tunnel(This should be always secodary)


If the primary is down tunnel traffic should switchover to secondary and again it shld switchover to primary once it back on opertional..


I looking for configuration example..


Thanks in advance..



Regards

Sateesh kumar.k

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
jan.nielsen Thu, 03/18/2010 - 17:25
User Badges:
  • Gold, 750 points or more

I don't get it, you have 3 locations, but you are saying one tunnel from A to B and one from A to C, but then you just have two seperate tunnels to two different sites ?

sateeshk10 Thu, 03/18/2010 - 17:56
User Badges:

Hi,


Thanks for your immediate response


We have a  back to back connectivty B to C....


If A wants to access application @ C, first A will land @ B and access the applications @ C thru back to bakc connectivity. here is the flow


A-B - C


If A- B is down, then A will land on C and will access the B thru back to back.here is the flow


A-C-B.


Bit confusion will be there as design is like that....


One more question can I run GRE tunnel on ASA/PIX?


Regards

Kumar

Sam Oesterling Fri, 03/19/2010 - 06:24
User Badges:

GRE tunnels are not supported on the ASA to my knowledge.


What routing protocol are you using?  I found an example of how to pass OSPF traffic over an IPSEC tunnel with the ASA.


http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00804acfea.shtml


If you are running a routing protocol like OSPF, when if one of your sites goes down you and have your traffic flow roll over to the other site.

Actions

This Discussion