cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
575
Views
2
Helpful
2
Replies

int dot11 0 stops working

t.fiala
Level 1
Level 1

I am using about 19 pieces of

AIR-AP1242AG-E-K9       12.4(10b)JA

Two of them show a frequent failure last time. The radio transceiver stops working suddenly without an obvious
reason. The "WiFi inspector" shows no radio sending, but the show command shows that Radio 0 is up (remote access via
Ethernet remains unaffected):

cw-bp1#sh int do 0
Dot11Radio0 is up, line protocol is up

After reboot the Access Point starts working properly.

Any opinion?

Regards,

Tomas

2 Replies 2

dancampb
Level 7
Level 7

When the AP is like this do a "show controller d0" and see if beacons and probes are enabled.  You also could look to see if the interface is wedged.

Dear dancampb,

thanks for your suggestions. I have read controller d0 right now:

...

Beacon Flags: 0; Beacons are enabled; Probes are enabled

...

This is of course the normal status, all radios are working well now.

How to discover  whether the interface is wedged?

BTW since my last post a new failure occured. In this case on the radio

bridge. None of the two involved APs allows a client association. So the

logs are simple and looks as follows - see the attached files.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: