Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
914
Views
0
Helpful
2
Replies

Need to synch NTP on 2100 and 4400 Wireless LAN Controllers

Go to solution
LEN SNEED
Level 1
Level 1

‎03-19-2010 07:26 AM - edited ‎07-03-2021 06:38 PM

I have 5 WLC's (3-2100, 2-4400) and need to synch the NTP server ip addresses on them.  I know how to do this but have a question.  Using the gui, once I apply the change to the NTP ip address and save the changes, will the WLCs need to be rebooted for them to complete synchronization?

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
dancampb
Level 7
Level 7

‎03-19-2010 07:28 AM

No, you don't have to reboot the controllers.  They should sync right up.

View solution in original post

0 Helpful
2 Replies 2

Go to solution
dancampb
Level 7
Level 7

‎03-19-2010 07:28 AM

No, you don't have to reboot the controllers.  They should sync right up.

0 Helpful

Go to solution
LEN SNEED
Level 1
Level 1
In response to dancampb

‎03-19-2010 07:29 AM

Thanks for the quick response.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card