Konstantin Dunaev Fri, 03/19/2010 - 16:42
User Badges:
  • Bronze, 100 points or more

just try to use "telnet x.x.x.x /source-interface Y"

Richard Burts Sat, 03/20/2010 - 20:30
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

David


Konstantin has given a good suggestion if you want to supply the source address in the command line. There is also an option that you may consider to specify the source address for telnet using the config command:

ip telnet source-interface


HTH


Rick

pompeychimes Sun, 03/21/2010 - 23:28
User Badges:
  • Bronze, 100 points or more

You can also specify the port...


telnet x.x.x.x 21 /source-interface f0/0


Please rate helpful posts


James

Actions

This Discussion