1st time for me to work with AIP SSM-10, i have ASA5510 and AIP SSM-10 ,
when plug the AIP SSM-10 what ip address i should give it and how can i be abile to make sure it is haveing ip connectivity like ping or traceroute . the point i am missing it is the ip address .
i gave an ip to the managment interface and i allowed ping but i couldn`t ping the AIP SSM-10 from the firewall .
1) From ASA, you would session into the module, and you would need to configure the ip address on that module using the "setup" command.
2) That ip address that you have just configured is the one assigned to the interface on that module.
3) That interface on the module needs to be physically connected to your network. You can configure a unique ip address in the same subnet as your ASA inside interface.
Here is a hardware diagram of the module with the port/interface:
Here is how to run the "setup" command: