03-22-2010 08:26 AM
Hi,
I have a Linksys SRW224G4 with me. I have successfuly connected the switch with console.
When i reboot the switch, it shows me something like this.
------ Performing the Power-On Self Test (POST) ------
UART Channel Loopback Test ......................... FAIL
After this message nothing comes up, its like the switch gets hanged up.
Sometime it actually works, but when it says " Autoboot 2 seconds to press ESC or RETURN" and even if i press ESC or Enter, nothing happens. Later on the switch reboots again by itself.
Can anyone help me out in this matter.
Basically i forgot the password which i had set about 6 months back, now i am stuck.
Looking forward for a quick and positive reply.
03-25-2010 08:07 AM
If it is still under warranty, I would suggest calling our support center.
You can find the links for the support center on this page, look to the right hand side of the web page:
https://www.myciscocommunity.com/community/smallbizsupport
HTH,
Andrew Lissitz
03-25-2010 08:13 AM
Dear,
Thanks for the reply. The switch is not in warranty any more. Can it be fixed or not.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: