Problem to display logging

Unanswered Question

Hello to all,

if i perform a "show logging" i can get this:

cme#show log

Syslog logging: enabled (11 messages dropped, 3 messages rate-limited,

                0 flushes, 0 overruns, xml disabled, filtering disabled)

No Active Message Discriminator.

No Inactive Message Discriminator.

    Console logging: level debugging, 23510 messages logged, xml disabled,

                     filtering disabled

    Monitor logging: level debugging, 5081 messages logged, xml disabled,

                     filtering disabled

        Logging to: vty514(208)

    Buffer logging:  level debugging, 19 messages logged, xml disabled,

                     filtering disabled

    Logging Exception size (4096 bytes)

    Count and timestamp logging messages: disabled

No active filter modules.

    Trap logging: level notifications, 11649 message lines logged

        Logging to  (udp port 514,  audit disabled,

              authentication disabled, encryption disabled, link up),

              11649 message lines logged,

              0 message lines rate-limited,

              0 message lines dropped-by-MD,

              xml disabled, sequence number disabled

              filtering disabled

Log Buffer (4096 bytes):

i need to see the 5081 messages that are logged in "Monitor logging" what is the correct way in order to display this messages?

thanks and regards.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
milan.kulik Tue, 03/23/2010 - 03:38
User Badges:
  • Red, 2250 points or more


IMHO, issuing "term monitor" will start displaying the messages on your terminal screen on-line.

But no way to display a message history.

See logging monitor at

and terminal monitor at




This Discussion