Cisco IOS QOS Solutions Configuration Guide, Release 12.4 says WFQ is enabled by default on interfaces configured for Multilink PPP.
But when I "show interface" on the multilink interface I see:
Queueing strategy: fifo
Oddly, the two T1 serial interfaces that are members of the multilink bundle show:
Queueing strategy: weighted fair [suspended, using FIFO]
"show queueing" doesn't indicate anything for the multilink interface:
Current fair queue configuration:
Interface Discard Dynamic Reserved Link Priority
threshold queues queues queues queues
Serial0/0:1 64 256 0 8 1
Serial0/1:1 64 256 0 8 1
Is the "Queueing strategy: fifo" shown for the multilink interface just wrong? Is WFQ being done only on the physical members of the MLP bundle after MLP has already picked one of the links for that flow?
(At the time of these "show" commands, the link was not congested.)
Thanks in advance for any insight on this issue !